How To Deal with Mold Infestation
There comes a time when we discover that there is mold growth in our homes, whether in the basement, attic, on the wall of our bedrooms and so forth, and of which we should deal with the situation immediately. You may be able to deal these spots of mold using DIY methods in smaller areas, but in large areas, it is better to get the help of the professionals, since the treatment could pose some health risks.
A qualified professional is advisable to be contacted so that there is proper mold inspection and that the type of mold is established with the kind of repairs to be undertaken. It is also suggested that you get the best mold inspector as you can afford since this is a potentially serious situation, and thus you should not look at the cost only, especially there are many mold inspectors out there.
Among the activities that will happen during a mold inspection would be the identification of any condition around your home which supports mold growth, pinpointing areas like water damage, odours and obvious signs of fungal growth and others that are the problem areas. The exterior of your property will also be inspected by the mold inspector aside from the interiors of your home, and the professional will check obvious signs of water damage and leaks that could come from broken gutters, or broken pipes, and so forth.
After performing the initial inspection visually, the mold inspector will then measure the moisture levels in the walls of your property. The inspector will pay special attention in areas like under the sink, around water heaters and other areas where there is a present of water, and the moisture level measurement is conducted at intervals like about two feet. In measuring the moisture level, a special meter is used, and the instrument is composed of two small pins which are inserted into the low area of the all, and then it gives a reading of the moisture level present. A moisture level that is acceptable is around 15% or below.
When there is growth mold observed, samples can be taken to precisely identify the type of pores present. After 3-4 days, expect the mold inspector to give you a report about the results.
One important thing to do before the arrival of the inspector who will conduct the mold inspection, is to keep doors and windows closed for a duration of 12 to 24 hours. This procedure will then make the results of the mold inspection as accurate as possible. In this manner, the air samples will not contain the air from the outside and the mold inspector can detect odours.